Online-Order | PRO Jump
We request you to take the required measurements very carefully, as we cannot accept responsibility for measurements not taken from us. (No exchange of custom-tailored Jump Suits possible.)
- The following pictures, which you can click to get a bigger view, will teach you the corresponding, exactly positions of each individual measuring point.
- Please make sure on the position and place of each individual measuring point.
- Take measurements on normal upright and relaxed body position.
- Measure exactly and without any kind of addition.
- Transfer the measured value of each measuring point into the field of the corresponding number in the measurement-form.
The position of measuring point no. 4 (Circumference of waist) is the key-point of the total symmetry of the suit. After measuring the value of this point, please keep the measuring-tape in this position. Take a pencil and make some little mark exactly below the measuring-tape on the left and right side (1cm above the hips-bones), as well as on the middle of the back (backbone).
Later this markings will be a kind of a base to measure the points no. 13, 14 and 15 and will avoid to overlapp any of this points.
Measuring points 1 - 20
ATTENTION!During production of your suit, we will treat your below measurements as careful as possible. Nevertheless, ordering a PRO Jump model is not a guarantee that in case of a FIS fitting control the suit will pass it without any objection. May some alteration will be still necessary on certain points.
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |